Ultrasonic Loop Controls - Coiltek, Inc. Ultrasonic Loop Controls - Coiltek, Inc.
HOME PRODUCTS DOWNLOADS CUSTOMER LINKS ABOUT US PRIVACY CONTACT US
Home > Products > Loop Controls
Coiltek Ultrasonic Loop Controls
LOOP CONTROLS
WINDING SYSTEMS
SPECIAL SYSTEMS
DOWNLOADS
CUSTOMER LINKS
coiltek warranty card
 
Have you filled out a warranty card?
 
CS-5000 Ultrasonic Loop Control: Hammerhead Accessory

The Hammerhead accessory broadens the effective beam of our standard CS-5000 transducer. This is extremely helpful when the loop saddle location changes. A typical example is shown in the drawing below with one of our standard loop controls on a press line. Set up correctly for a full coil, the loop sensor fails to operate properly when the coil reaches core, as the beam is deflected.

The following drawing shows the same unit outfitted with the Hammerhead (note that the stand is moved 6 inches toward the decoiler).

coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
For manuals and other support documentation for the
CS-5000/CS-5100, visit our downloads section.
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory

With the Hammerhead, there is always a working transducer element over the saddle, regardless of the shift that occurs as the coil dwindles.

Shifting loop saddles occur even when there’s a straightener involved. If the cascade rolls of the straightener and press feed sit at different levels, the loop shifts laterally as well as vertically with each feed of the press. Further, variances in stock thickness can change where the valley of the loop is located from job to job.
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
The hammerhead can be installed on CS-5000 stands you already have. The drawing below shows the simplicity of the modification. It basically plots on. If you have an application with a loop that shifts dramatically, ask about the hammerhead option.
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
coiltek CS-5000 loop control hammerhead accessory
   

Questions on any of our products? Contact us to find out more!
Copyright © 2004-2008 coiltek ®